Western Telematic MPC-20VS16-3 - Manual (Page 72)

5-41
Basic Configuration
5.7.1.2. Example 2: Change Plug A5 to Priority 2
In the second Example shown in Figure 5.12, we start out with Boot Priorities for the
plugs set as they were at the end of Example 1; Plug A3 is first, Plug A1 is second, Plug
A2 is third, Plug A4 is fourth, and Plug A6 is sixth.
Next, the Boot Priority for Plug A5 is changed to Priority 2. This means that Plug A3
will continue to be switched on first after a reboot, but now Plug A5 will be switched on
second, Plug A3 will be third, Plug A2 will be fourth, Plug A4 will be fifth and Plug A6 will
still be sixth.
Once again, note that when the Boot Priority for Plug A5 is set to 2, the Boot Priorities for
all plugs that were previously Booted before plug A5 are now lowered by a factor of one
(Plug No.) Priority
(A1) 2
(A2) 3
(A3) 1
(A4) 4
(A5) 5
(A6) 6
BEFORE
2
(Plug No.) Priority
(A1) 3
(A2) 4
(A3) 1
(A4) 5
(A5) 2
(A6) 6
AFTER (Assign Plug A5
to Priority 2)
Figure 5.12: Boot Priority Example 2