Western Telematic MPC-20VS16-3 - Manual (Page 48)

5-17
Basic Configuration
To erase log data, access command mode via the Text Interface, using an account that
permits Administrator level commands, then type
/L and press [Enter] to access the
Display Logs menu and then proceed as follows:
• Audit Log: At the Display Logs menu, type 1 and then press [Enter]. When the
Audit Log appears, type E and press [Enter] to erases the Audit Log.
• Alarm Log: At the Display Logs menu, type 2 and then press [Enter]. When the
Alarm Log appears, type E and press [Enter] to erase the Alarm Log.
• Current Metering Log: At the Display Logs menu, type 3 and press [Enter].
When the Current Metering Log menu appears, type 4 and press [Enter] to erase
the Current Metering Log.
Notes:
• The MPC dedicates a fixed amount of internal memory for Audit Log records,
and if log records are allowed to accumulate until this memory is filled,
memory will eventually "wrap around," and older records will be overwritten
by newer records.
• To save the Audit Log or Alarm Log as an ASCII file via the Web Browser
Interface, click on the "Logs" link on the left hand side of the screen. When
the Logs menu appears, right click the link for the Audit Log or Alarm Log,
select "Save Target As", select text format, and save the document with a ".txt"
filename extension.
• Note that once records have been erased, they cannot be recovered.