WatchGuard Technologies WatchGuard Firebox SOHO 6 - Manual (Page 126)

Chapter 10: Support Resources
108 WatchGuard Firebox SOHO 6.1
four, numbered, Ethernet ports (labeled 0-3) and reload the
configuration.
If the Mode light is blinking:
The SOHO 6 requires a DHCP assigned IP address for the
external interface, but did not receive it. The WAN port is not
connected to another appliance, the physical connection is
faulty, or the other appliance is not operating properly.
How do I register my SOHO 6 with the LiveSecurity
Service?
Register online by activating your bundled LiveSecurity® Service
subscription. Activation entitles you to receive threat alert
notifications, expert security advice, free anti-virus protection,
software updates, technical support by web or phone, and access
to extensive online help resources. To activate, make a note of your
SOHO serial number, then use your Web browser to go to:
http://www.watchguard.com/activate
For more information, see “Register your SOHO 6 and Activate the
LiveSecurity Service” on page 27.
How do I restart my SOHO 6?
1 With your Web browser, go to the System Status page using
the Trusted IP address of the SOHO 6.
For example, if using the default IP address, go to: http://192.168.111.1
2 Click Reboot.
3 Wait for the SOHO 6 to complete the process. The MODE light
on the front of the SOHO 6 will turn off, then back on. The
SOHO 6 takes 30 seconds to boot up.