WatchGuard Technologies WatchGuard Firebox SOHO 6 - Manual (Page 52)

Chapter 4: Configure the Network Interfaces
34 WatchGuard Firebox SOHO 6.1
4 Enter the TCP/IP settings you recorded from your computer
during the installation process. Refer to the table in, “Review
and record your current TCP/IP settings” on page 12.
5 Click Submit.
The configuration change is saved to the SOHO 6.
Configure the SOHO 6 External Network for
PPPoE
While less common, PPPoE is another method for an ISP to assign
IP addresses. Check the information and manuals sent to you by
your ISP to see if they use PPPoE. If you cannot find this
information, contact your ISP and ask them. You need your PPPoE
login name and password.
To configure the SOHO 6 for PPPoE:
1 Open your Web browser and click Stop.
At this point, the Internet connection is not fully configured, and the
computer cannot load your home page from the Internet. However, the
computer can access the configuration Web pages installed on the
SOHO 6.
2 With your Web browser, go to the System Status page using the
trusted IP address of the SOHO 6.
For example, if using the default IP address, go to: http://192.168.111.1
3 From the navigation bar on the left side, select
Network => External.
The External Network configuration page appears.