WatchGuard Technologies WatchGuard Firebox SOHO 6 User Manual
Page 128
Chapter 10: Support Resources
110
WatchGuard Firebox SOHO 6.1
a DSL router, set the NAT feature of the DSL router to bridge-only
mode.
How do I install and configure the SOHO 6 using a
Macintosh (or other) operating system?
Installation instructions for the Macintosh and other operating
systems are on the WatchGuard Web site at:
How do I know whether the cables are connected correctly
to my SOHO 6?
There are fourteen lights on the front of the SOHO 6 grouped in
pairs. The link light labeled WAN tells you if your SOHO 6 is
connected to your modem. If this light is not lit, the SOHO 6 is not
connected to your modem. Check to make sure that both sides of
the cable are connected and that your Internet connection is active.
The link lights labeled 0 through 3 correspond to the four
numbered Ethernet ports of the trusted network. They tell you if
the SOHO 6 is connected to a computer or hub. If the lights are not
lit, the SOHO 6 is not connected to the computer or hub. Check to
make sure that both sides of the cable are connected and that the
computer or hub has power.
I can connect to the configuration screen; why can’t I
browse the Internet?
This means that the SOHO 6 is on, but something is wrong with
the connection from the SOHO 6 to the Internet. Make sure the
cable or DSL modem is connected correctly and has power. Also
check the link light on your modem as well as the WAN link light
on the SOHO 6.
If you continue to have trouble connecting to the Internet, call your
ISP.