WatchGuard Technologies WatchGuard Firebox SOHO 6 User Manual
Page 40
Chapter 2: Installation
22
WatchGuard Firebox SOHO 6.1
2
Disconnect the Ethernet cable that runs from your DSL/cable
modem or other Internet connection to your computer and
connect it to the WAN port on the SOHO 6.
The SOHO 6 is now connected directly to the modem or other Internet
connection.
3
Connect one end of the straight-through Ethernet cable
supplied with your SOHO 6 into any one of the four,
numbered, Ethernet ports (labeled 0-3) on the SOHO 6.
Connect the other end into the uplink port of the hub.
The SOHO 6 is now connected to the Internet and your hub.
4
Connect Ethernet cables to the uplink ports of the hub and to
the Ethernet ports of each of your computers.
5
If you connect to the Internet using a DSL/cable modem,
restore the power to this device. When the indicator lights of
the modem stop flashing the modem is ready for use.
6
Attach the AC adapter to the SOHO 6 and connect it to a power
source.
7
Restart your computer.
For information on the factory default configuration options, see
“Default Factory Settings” on page 25. For specialized
configurations, see “Configure Your External Network” on
page 31, as well as, “Configure the Trusted Network” on page 36.