Yamaha CVP-103M EN - Manual (Page 140)

140
CVP-103
X Select the file operation.
File operations cannot be performed
while the [SONG] lamp is lit. Exit the
Song mode before attempting to
perform a file function.
Use the second LCD button from the right to select the desired file opera-
tion:
LOAD, SAVE, DELETE or NAME.
C Press the START button.
➔ The file operation begins.
The subsequent steps for each file operation depend on the operation
you’ve selected. Refer to the corresponding instructions for each opera-
tion below.
■ LOAD
.........................................................................................................................................
When you select LOAD, the Load function display will appear. The origi-
nal internal data will be replaced when you execute the Load operation. Be
sure to save all important data to disk (see below) before using the Load op-
eration.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
138
Disk
First, select the desired file to be loaded. Press either of the two leftmost
LCD buttons to select the file, then press the OK button.
➔ An “ Are you sure? ” message is displayed. Press the YES button to
load the selected file, or the NO button to abort the Load operation.
■ SAVE
.........................................................................................................................................
When you select SAVE, the name entry function display for the file to be
saved will appear.
Press the > button to move the underline cursor, and select the character
position of the file name. (File names can contain up to twelve characters.)
➾ Use the data dial or [–] and [+] buttons to highlight the characters to be
input.