Yamaha CVP-103M EN - Manual (Page 158)

158
CVP-103
The Clavinova is equipped with jacks that let you connect a variety of audio devices. You
can connect headphones, a stereo system, or PA equipment for audio output, as well as
input from a tone generator or other instrument.
Be sure to turn off the power when connecting or disconnecting audio equipment, as fail-
ing to do so can result in damage to speakers and other problems.
CHAPTER
9: Connections
Audio Connections
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Recommended Headphones:
Yamaha HPE-160 headphones
Headphones
To use headphones, connect them to one of
the [PHONES] jacks (standard 1/4" phone
jacks) located below the left end of the key-
board. The Clavinova’s built-in speaker system
is automatically shut off when a pair of head-
phones are connected. Two people can enjoy
listening to the Clavinova together by connect-
ing two pairs of headphones to the two jacks.
PHONES
You can connect the Clavinova to a wide range of audio equipment by
using the AUX IN and AUX OUT jacks, which are located at the left end
of the unit on the rear panel.
■ AUX IN Jacks
..........................................................................................................
Audio Input and Output
CAUTION
Never connect the Clavinova’s AUX
OUT jacks to its AUX IN jacks, either
directly or via external audio equip-
ment. Such connections could result
in a feedback loop that will make nor-
mal performance impossible, and may
even damage the Clavinova.
The volume of the audio signal input at
the AUX IN jacks is affected by the
[MASTER VOLUME] slider.
The sounds of other instruments or
tone generator modules can be output
through the speaker system of the
Clavinova by connecting audio cables to
the AUX IN jacks as shown here.
Use the AUX IN [L/L+R] jack for
monophonic input. For stereo input, con-
nect the left channel output to the AUX
IN [L/L+R] jack, and the right channel
output to the AUX IN [R] jack.
Tone Generator
AUX IN
R L/L + R
156
CAUTION