Xantrex Technology XPower Powerpack 400 Plus - Manual (Page 63)

Replacing the Incandescent Light
975-0162-01-01 4-5
4. After removing the old battery, position the new battery
close to the back of the XPower Powerpack.
Make sure the positive battery terminal is next to the red
positive (+) internal cable and the black negative terminal
is next to the black negative (–) internal cable.
5. Securely fasten the bolt and washer that holds the red
positive (+) cable to the positive (+) battery terminal and
the black negative (–) cable to the negative (–) battery
terminal.
6. Do not overtighten the bolt. Consult the battery
manufacturer for torque specifications.
7. On the XPower Powerpack, replace the battery cover and
the four fasteners.
8. Dispose of the old battery in an environmentally
responsible manner.
Replacing the Incandescent Light
To replace a light bulb:
1. Turn the light switch off.
2. Unscrew the cover and lens.
3. Gently grasp the bulb and pull to remove the light
reflector assembly and the bulb.
4. While holding the light reflector assembly, gently
unscrew the black knob at the back of the assembly.
5. Remove the old bulb and insert a replacement bulb of the
same type and rating into the light reflector assembly.
Replacement Lamp: Part # 030-9951-01 5 watt 12-v
lamp.
6. Holding the light reflector assembly, gently screw the
black knob on to the back of the assembly.
7. Reattach the lens and cover.
975-0162-01-01_Rev-C.book Page 5 Friday, October 20, 2006 10:40 AM