Xilinx MIcroblaze Development Spartan-3E 1600E - Manual (Page 127)

MicroBlaze Development Kit Spartan-3E 1600 Edition User Guide 125
UG257 (v1.1) December 5, 2007 www.xilinx.com
Connectorless Debugging Port Landing Pads (J6) R
Connectorless Debugging Port Landing Pads (J6)
Landing pads for a connectorless debugging port are provided as header J6, shown in
Figure 15-1, page 115 . There is no physical connector on the board. Instead a connectorless
probe, such as those available from Agilent, provides an interface to a logic analyzer. This
debugging port is intended primarily for the Xilinx ChipScope Pro software with the
Agilent’s FPGA Dynamic Probe. It can, however, be used with either the Agilent or
Tektronix probes, without the ChipScope software, using FPGA Editor’s probe command.
Refer to “Related Resources,” page 126 for more information on the ChipScope Pro tool,
probes, and connectors.
Table 15-3 provides the connector pinout. Only 18 FPGA pins attach to the connector; the
remaining connector pads are unconnected. All 18 FPGA pins are shared with the FX2
connector (J3) and the 6-pin accessory port connectors (J1, J2, and J4). See Table 15-1,
page 117 for more information on how these pins are shared.
Table 15-3: Connectorless Debugging Port Landing Pads (J6)
Signal Name FPGA Pin
Connectorless
Landing Pads FPGA Pin Signal Name
FX2_IO1 B4 A1 B1 GND GND
FX2_IO2 A4 A2 B2 D5 FX2_IO3
GND GND A3 B3 C5 FX2_IO4
FX2_IO5 A6 A4 B4 GND GND
FX2_IO6 B6 A5 B5 E7 FX2_IO7
GND GND A6 B6 F7 FX2_IO8
FX2_IO9 D7 A7 B7 GND GND
FX2_IO10 C7 A8 B8 F8 FX2_IO11
GND GND A9 B9 E8 FX2_IO12
FX2_IO13 F9 A10 B10 GND GND
FX2_IO14 E9 A11 B11 D11 FX2_IO15
GND GND A12 B12 C11 FX2_IO16
FX2_IO17 F11 A13 B13 GND GND
FX2_IO18 E11 A14 B14
A15 B15
A16 B16
A17 B17
A18 B18
A19 B19
A20 B20
A21 B21
A22 B22
A23 B23
A24 B24
A25 B25
A26 B26
A27 B27