Xilinx MIcroblaze Development Spartan-3E 1600E - Manual (Page 49)

MicroBlaze Development Kit Spartan-3E 1600 Edition User Guide 47
UG257 (v1.1) December 5, 2007 www.xilinx.com
LCD Controller R
Disabled
If the LCD_E enable signal is Low, all other inputs to the LCD are ignored.
Clear Display
Clear the display and return the cursor to the home position, the top-left corner.
This command writes a blank space (ASCII/ANSI character code 0x20) into all DD RAM
addresses. The address counter is reset to 0, location 0x00 in DD RAM. Clears all option
settings. The I/D control bit is set to 1 (increment address counter mode) in the Entry Mode
Set command.
Execution Time: 82 Ps – 1.64 ms
Return Cursor Home
Return the cursor to the home position, the top-left corner. DD RAM contents are
unaffected. Also returns the display being shifted to the original position, shown in
Figure 5-3 .
The address counter is reset to 0, location 0x00 in DD RAM. The display is returned to its
original status if it was shifted. The cursor or blink move to the top-left character location.
Execution Time: 40 Ps – 1.6 ms
Entry Mode Set
Sets the cursor move direction and specifies whether or not to shift the display.
These operations are performed during data reads and writes.
Execution Time: 40 Ps
Bit DB1: (I/D) Increment/Decrement
Set CG RAM Address 0 0 0 1 A5 A4 A3 A2 A1 A0
Set DD RAM Address 0 0 1 A6 A5 A4 A3 A2 A1 A0
Read Busy Flag and
Address 0 1 BF A6 A5 A4 A3 A2 A1 A0
Write Data to CG RAM or
DD RAM 1 0 D7 D6 D5 D4 D3 D2 D1 D0
Read Data from CG RAM
or DD RAM 1 1 D7 D6 D5 D4 D3 D2 D1 D0
Table 5-3: LCD Character Display Command Set (Continued)
Function
LC
D_RS
LCD_R
W
Upper Nibble Lower Nibble
DB7 DB6 DB5 DB4 DB3 DB2 DB1 DB0
0 Auto-decrement address counter. Cursor/blink moves to left.
1 Auto-increment address counter. Cursor/blink moves to right.