Spi communication details, Communication protocol – Xilinx MIcroblaze Development Spartan-3E 1600E User Manual

Page 73

Advertising
background image

MicroBlaze Development Kit Spartan-3E 1600 Edition User Guide

71

UG257 (v1.1) December 5, 2007

www.xilinx.com

SPI Communication

R

Although the StrataFlash PROM is a parallel device, its least-significant data bit is shared

with the SPI_MISO signal.

SPI Communication Details

Figure 9-3

shows a detailed example of the SPI bus timing. Each bit is transmitted or

received relative to the SPI_SCK clock signal. The bus is fully static and supports clocks

rate up to the maximum of 50 MHz. However, check all timing parameters using the

LTC2624 data sheet if operating at or close to the maximum speed.

After driving the DAC_CS slave select signal Low, the FPGA transmits data on the

SPI_MOSI signal, MSB first. The LTC2624 captures input data (SPI_MOSI) on the rising

edge of SPI_SCK; the data must be valid for at least 4 ns relative to the rising clock edge.
The LTC2624 DAC transmits its data on the SPI_MISO signal on the falling edge of

SPI_SCK. The FPGA captures this data on the next rising SPI_SCK edge. The FPGA must

read the first SPI_MISO value on the first rising SPI_SCK edge after DAC_CS goes Low.

Otherwise, bit 31 is missed.
After transmitting all 32 data bits, the FPGA completes the SPI bus transaction by

returning the DAC_CS slave select signal High. The High-going edge starts the actual

digital-to-analog conversion process within the DAC.

Communication Protocol

Figure 9-4

shows the communications protocol required to interface with the LTC2624

DAC. The DAC supports both a 24-bit and 32-bit protocol. The 32-bit protocol is shown.
Inside the D/A converter, the SPI interface is formed by a 32-bit shift register. Each 32-bit

command word consists of a command, an address, followed by data value. As a new

command enters the DAC, the previous 32-bit command word is echoed back to the

Table 9-2:

Disabled Devices on the SPI Bus

Signal

Disabled Device

Disable Value

SPI_SS_B

SPI serial Flash

1

AMP_CS

Programmable pre-amplifier

1

AD_CONV

Analog-to-Digital Converter (ADC)

0

SF_CE0

StrataFlash Parallel Flash PROM

1

FPGA_INIT_B

Platform Flash PROM

1

Figure 9-3:

SPI Communication Waveforms

DAC_CS

SPI_MOSI

SPI_SCK

SPI_MISO

Previous 31

31

30

29

Previous 30

Previous 29

UG257_09_03_060606

Advertising