Options and defaults -17 – Zhone Technologies 600 User Manual

Page 167

Advertising
background image

Server Cards

6-17

ACS-PRI/BRI Card

ACS-PRI/BRI Card User Screens and Settings

Table 6-3. Options and Defaults

STATE

The State setting determines the status of each D channel. The available options are stdby,
conf or actv.

As with most other cards in the system, the stdby (standby) setting keeps the resource to
which it is associated (in this case, the associated D channel) in inactive mode. When a D
channel is in stdby, it does not use any system resources such as B channels or processor time
on the ACS-PRI/BRI server card.

When a D channel is in actv (active) state, all B channels are reserved, and the system attempts
to maintain its D channel session with the other end (e.g. switch or PBX) of the D channel. If
the D channel loses contact with the other end when it is in the active state, a D channel alarm
will be generated.

Because there are times when users want to temporarily suspend the D channel session with
the other end (e.g., when adding additional B channels to the system), but do not want to lose
all the D channel settings already completed (see caution below), a third state has been added
to the D channels on the ACS-PRI/BRI card. The conf (configure) state is used to initially
configure the D channel and to change the configuration later.

When a D channel is in the configure state, it does not attempt to maintain a protocol session
with the far end. Also, B channels assigned to a D channel that is in the configure state are
reserved for the D channel, and thus are not available to other D channels nor to other system
modules (e.g. user ports or cross-connect) that might want to use them as DS0s. The only way
to free up B channels taken by a D channel in configure state is to free each resource
individually, or to put the D channel back into standby state.

Parameter

User Options

Default

STATE

stdby conf actv

stdby

WAN

w1-1 w1-2 w2-1 w2-2 w3-1 w3-2 w4-1 w4-2 w1-1

TS

1-24 1-31

24

RATE

56k 64k

64k

SIDE

user net

user

SW. TYPE

fjtsu att_4 dms_1 dms_2 att_5 ni_2 dpnss dass2
net_5 mcl

fjtsu

DATA INV

no yes

no

Advertising