Zhone Technologies 600 - Manual (Page 27)

Server Cards 2-3
FRS Card ACS-FRS Card User Screens and Settings
2.3 ACS-FRS Card User Screens and Settings
2.3.1 ACS-FRS Card Main Screen
You must configure the ACS-FRS card for operation after installing it. This is done in the
ACS-FRS Card Main Screen (Figure 2-1). To go to that screen, highlight the desired
ACS-FRS card in the System Main Screen and press <Enter>.
Figure 2-1.Typical ACS-FRS Card Main Screen (ports C1 to C4)
The 68 logical ports of the card are labeled C1 to C4 and 1 to 64. However, numbered ports 1
to 64 do not appear in the above display. To see those ports, press the "<" and ">" keys to scroll
through them, eight at a time. Figure 2-2 shows an ACS-FRS card Main Screen display for the
first eight numbered ports.
The ports C1 to C4 cannot be used for Nx56k, only port 1 to 64 can.
Both the IPR (883060/883160) and the PM-IOR (828060) cards be used with the ACS-FRS
card. The PM-IOR card however, is limited to only 14 PVCs per card, whereas the maximum
number of PVCs available on the IPR card is 128.
When connecting the ACS-FRS card to the IPR or the PM-IOR, one of the 64 ports available
will be used for the communication between the two.