Zhone Technologies 600 - Manual (Page 29)

Server Cards 2-5
FRS Card ACS-FRS Card User Screens and Settings
Table 2-1. ACS-FRS Card Main Screen Actions
Table 2-2. ACS-FRS Card Main Screen Option Settings and Defaults
Notes:
1. ansi, ccitt, and lmi can only be selected when Port Type is changed to any selection
other than none.
2. When Port Type is u-dce or nni, this parameter will let you change the Error Threshold,
Poll Verify Timer, and Events Counter settings.
3. When Port Type is u-dte or nni, this parameter will let you change the Error Threshold,
Poll Interval Timer, Events Counter, and Full Status Frequency.
4. Press <Enter> to select the desired Congestion Threshold percentages.
5. If connected to a user port, this displays user slot number and port (e.g. U1-2).
Action Function
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Redraws the screen.
< and > Lets you scroll through the 68 logical ports assignable on each ACS-FRS
card.
Endp Brings up the PVC Endpoints Screen where endpoints for each PVC are
assigned. See the PVC Endpoints Screen section of this chapter.
Circ Brings up the Circuits Screen where alternate endpoints and endpoint
switching are assigned. See the Circuits section of this chapter.
Perf Initiates Port Performance Monitoring of the selected ACS-FRS card port.
Refer to Port Performance Data section of this chapter.
Lmi Brings up the LMI Screen where additional performance statistics are
stored. See the LMI section of this chapter.
Glob Brings up the Global Screen that identifies the ACS-FRS card by IP number
and netmask. See the Global Setup section of this chapter.
Main Returns to the System Main Screen. If changes are made to settings and not
saved, you will be prompted to save or lose changes.
Parameter User Options Notes Default
STATE stdby actv stdby
WAN/SRV none w1-1 w1-2 w2-1 w2-2 w3-1
w3-2 w4-1 w4-2 none
TS n/a table n/a
RATE 64k 64
PORT TYPE none u-dce nni u-dte frad none
LOOPBACK off line local off
LMI none ansi ccitt lmi 1 none
DCE PARAM n/a enabl 2 n/a
DTE PARAM n/a enabl 3 n/a
ASYNC no yes no
CONG THRS enabl 1%-100% 4 enabl (95%)