Setting the bottom margin option, Purpose, Path to setting the mismatch queueing enable – Xerox 8825 User Manual
Page 117: Setting the pen palette options, Pen palette purpose, Assigning a palette number, Bottom margin purpose
8825/8830 Controller Setup Manual for Firmware 6.0
101
Configuring the Printer Processing Defaults (continued)
Setting the Bottom Margin option
Bottom Margin Purpose
The purpose of this option is to set the default value for the bottom margin of
the print in millimeters.
Range: 0 – 2540 mm
Default: 5 mm
PATH TO BOTTOM MARGIN OPTION
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, press [NEXT] until <PROCESSING DEFAULTS> is
displayed, press [ENTER], display <ELECTRONIC COLLATION>, press
[NEXT] until <MARGIN BOTTOM> is displayed.
SELECTING THE BOTTOM MARGIN OPTION
Press the ENTER key to change the option. Enter the value desired on the
Keypad (0 - 2540) then press the ENTER key.
EXITING THE BOTTOM MARGIN OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.