Setting the left margin option, Exiting vellum mismatch options, Setting the mismatch queueing enable (on or off) – Xerox 8825 User Manual
Page 118: Selecting the raster stamp scaling mode option, Left margin purpose
8825/8830 Controller Setup Manual for Firmware 6.0
102
Configuring the Printer Processing Defaults (continued)
Setting the Left Margin option
Left Margin Purpose
The purpose of this option is to set the default value for the left margin of the
print in millimeters.
Range: 0 – 2540 mm
Default: 5 mm
PATH TO LEFT MARGIN OPTION
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, press [NEXT] until <PROCESSING DEFAULTS> is
displayed, press [ENTER], display <ELECTRONIC COLLATION>, press
[NEXT] until <MARGIN LEFT> is displayed.
SELECTING THE LEFT MARGIN OPTION
Press the ENTER key to change the option. Enter the value desired on the
Keypad (0 - 2540) then press the ENTER key.
EXITING THE LEFT MARGIN OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.