Xerox 8825 - Manual (Page 70)

8825/8830 Controller Setup Manual for Firmware 6.0 54
Setting the TCP/IP Options (continued)
Path to the TCP/IP options
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, press [NEXT], display <SETUP I/O PORTS>, press
[ENTER], display <SCSI>, press [NEXT] until <ETHERNET TCP/IP> is
displayed.
SELECTING THE TCP/IP OPTIONS
Press ENTER to display PORT ENABLE. Press the ENTER key to change
the option. Press the NEXT key to select either PRINTER, ADVANCED or
OFF, when the desired mode is displayed, press the ENTER key.
Press the NEXT key to display TCP/IP address. Press ENTER to change
settings. Enter the desired TCP/IP address at the keyboard, then press the
ENTER key.
Press the NEXT key followed by the ENTER key to change the net mask
address. Enter the desired TCP/IP net mask address at the keyboard, then
press the ENTER key.
Press the NEXT key followed by the ENTER key to change the gateway
address. Enter the desired TCP/IP gateway address at the keyboard, then
press the ENTER key.
Press the NEXT key followed by the ENTER key to change the DHCP option.
Press the NEXT key to select either ON or OFF. When the desired mode is
displayed press the ENTER key.
Press the NEXT key followed by the ENTER key to change the RARP option.
Press the NEXT key to select ON or OFF, then press the ENTER key.
EXITING THE TCP/IP OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.