Setting the right margin option, Selecting the raster stamp rotate set option, Exiting the raster stamp rotate set option – Xerox 8825 User Manual
Page 119: Raster stamp scaling mode & numeric option, Purpose of raster stamp scaling mode & numeric, Path to the raster stamp scaling mode option, Right margin purpose
8825/8830 Controller Setup Manual for Firmware 6.0
103
Configuring the Printer Processing Defaults (continued)
Setting the Right Margin option
Right Margin Purpose
The purpose of this option is to set the default value for the right margin of
the print in millimeters.
Range: 0 – 2540 mm
Default: 5 mm
PATH TO RIGHT MARGIN OPTION
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, press [NEXT] until <PROCESSING DEFAULTS> is
displayed, press [ENTER], display <ELECTRONIC COLLATION>, press
[NEXT] until <MARGIN RIGHT> is displayed.
SELECTING THE RIGHT MARGIN OPTION
Press the ENTER key to change the option. Enter the value desired on the
Keypad (0 - 2540) then press the ENTER key.
EXITING THE BOTTOM MARGIN OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.