Setting the vector halftone option, Enabling each print job to be followed by a print, Copy of the job processing parameters used by t – Xerox 8825 User Manual
Page 82: Print job, The vector halftone purpose
8825/8830 Controller Setup Manual for Firmware 6.0
66
Configuring the Printer Setup Defaults (continued)
Setting the Vector Halftone Option
Note: This feature is not supported when using PostScript.
If problems occur with fine lines being omitted, mainly in filled areas, try
selecting LINE OPTIMIZED.
The Vector Halftone Purpose
This option sets the default mode used to process Halftone images.
Range: LINE OPTIMIZED, or AREA OPTIMIZED
Default: AREA OPTIMIZED
PATH TO THE VECTOR HALFTONE OPTION
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, press [NEXT] until <SETUP PRINTER> is displayed,
press [ENTER], display <BANNER PAGE>, press [NEXT] until < VECTOR
HALFTONE > is displayed.
SELECTING THE VECTOR HALFTONE OPTION
Press the ENTER key to change the option. Press the NEXT key to select
AREA OPTIMIZED or LINE OPTIMIZED, then press the ENTER key with the
desired selection displayed.
EXITING THE VECTOR HALFTONE OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.