Xerox 8825 - Manual (Page 84)

8825/8830 Controller Setup Manual for Firmware 6.0 68
Configuring the Printer Setup Defaults (continued)
Setting The Time Out Option
The Purpose of the Time Out Setting
The Time Out adjustment (range 5 to 300 seconds) sets the time out duration
of the Serial and Parallel communication ports.
The default setting is 5 seconds.
PATH TO THE TIME OUT OPTION
Display <IDLE>, press [OFF-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, press [NEXT] until <SETUP PRINTER> is displayed,
press [ENTER], display <BANNER PAGE>, press [NEXT] until <TIME OUT >
is displayed.
SELECTING THE TIME OUT OPTION
Press the ENTER key to change time out value. Input value (5 - 300) on the
Keypad. After the desired value is displayed, press the ENTER key.
EXITING THE TIME OUT OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.