3Com 3500 - Manual (Page 225)

fddi station connectPolicy 225
fddi station
✓
3500
✓
9000
9400
3900
9300
connectPolicy
Sets the connectPolicy attribute string that represents the connection
policies in effect on a station. A connection’s type is defined by the types
of the two ports involved in the connection.
Valid Minimum Abbreviation
fd station c
Important Considerations
■
Port types can be A, B, M, or S.
■
The system FDDI ports are type A or type B for Dual Attachment
Station (DAS) ports and type M for Single Attachment Station (SAS)
ports.
■
By default, all connections to the system ports are valid. M-M
connections are accepted so that one CoreBuilder
® 3500 port can be
connected to another system port.
Options
Bit to Set for Rejecting a Station Connection
Prompt Description Possible Values [Default]
Ports One or more FDDI station ports
for which you want to set the
connection policies
■
Any of the
available ports
on the installed
FDDI modules
■
all
–
connectPolicy Bit string that represents the
connection policies in effect on
that station See next table –
This
Connection
Is Rejected
If This Bit Is Set Connection Rules
A-A 0 Undesirable peer connection that creates
twisted primary and secondary rings; notify
station management (SMT).
A-B 1 Normal trunk ring peer connection.
A-S 2 Undesirable peer connection that creates a
wrapped ring; notify SMT.