3Com 3500 - Manual (Page 618)

618 C HAPTER 20: IPX
✓ 3500
✓ 9000
9400
3900
9300
ipx route static For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Defines a static route.
Valid Minimum Abbreviation
ipx ro st
Important Considerations
■
Before you define static routes on the system, define at least one IPX
interface. See “ipx interface define” earlier in this chapter for more
details.
■
Static routes remain in the routing table until you remove them or
until you remove the corresponding interface.
■
If an interface goes down, routes are temporarily removed from the
routing table until the interface comes back up.
■
Static routes take precedence over dynamically learned routes to the
same destination. You can have a maximum of 32 static routes.
Options
Prompt Description Possible Values [Default]
IPX network
address 4-byte IPX address of the
interface. The address must be
unique within the network. 0x1 – 0xfffffffe –
Hops Number of hops, or number of
routers that must be crossed to
reach the network segment. 1 – 15 1
Interface
number Interface number to associate
with the route. Depends on
number of configured IPX
interfaces.
■
A selectable
IPX interface
number
■
? (for a list of
selectable IPX
interfaces)
–
Node address 6-byte MAC address of the
router that can forward packets
to the segment. A node address
of all zeroes
(
00-00-00-00-00-00 ) means
that the route is connected
directly to the router.
A node address
in the format
xx-xx-xx-xx-xx-xx –