3Com 3500 - Manual (Page 624)

624 C HAPTER 20: IPX
✓ 3500
✓ 9000
9400
3900
9300
ipx server static For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Defines a static IPX server.
Valid Minimum Abbreviation
ipx ser st
Important Considerations
■
Static servers remain in the table until you remove them, until you
remove the corresponding interface, or until you remove the route to
the corresponding network address.
■
A static server must have an IPX network address that corresponds to
a configured interface or to a static route. If an interface goes down,
any static servers on that interface are permanently removed from the
server table until the interface comes back up.
■
Static servers take precedence over dynamically learned servers to the
same destination. You can have a maximum of 32 static servers.
■
Before you define static servers on the system, first define at least one
IPX interface. See “ipx interface define”earlier in this chapter for more
details.
Options
Prompt Description Possible Values [Default]
Interface index Interface index number for the
server
■
A selectable IPX
interface index
■
? (for a list of
selectable IPX
interfaces)
–
Service type Number for the type of service
that the server performs
■
*
■
0x1 – 0xffff
*
Service name Service name of the server, up to
79 characters
■
Any selectable
service name
■
? (for a list of
selectable
names)
–
IPX network
address IPX network address of the server 0x0 – 0xfffffffe –
Socket value Socket value of the server 0x0 – 0xffff –
Node address Node address of the server –
Hops Number of hops to the server 0 – 15 –