3Com 3500 - Manual (Page 422)

422 C HAPTER 16: I NTERNET P ROTOCOL (IP)
✓ 3500
✓ 9000
✓ 9400
✓
3900
✓
9300
ip route static For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Defines a static route.
Valid Minimum Abbreviation
ip route s
Important Considerations
■
Before you can define static routes, you must define at least one IP
interface. See “ip interface define (3500/9000 Layer 3)” earlier in this
chapter for more information.
■
For the CoreBuilder 3500, you can define up to 256 static routes.
■
For the other platforms, you can define up to 64 static routes.
■
Static routes remain in the table; you must remove them before you
can remove the corresponding interface.
■
Static routes take precedence over dynamically learned routes to the
same destination
■
Static routes are included in periodic Routing Information Protocol
(RIP) updates that the system sends.
Options
Prompt Description Possible Values [Default]
Destination IP
address IP address of the
destination network,
subnetwork, or host
for this route A valid IP address –
Subnet mask Subnet mask for the
specified IP address A valid subnet mask Based on
specified IP
address
Gateway IP
address IP address of the
gateway that this
route uses A valid router address –