Acnodes RMC 7155 - Manual (Page 14)

RMC 7155
14” short depth server
14
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
3.3 Control Panel LEDs
The control panel located on the front of the RMC 7150 chassis has five LEDs. These LEDs provide you with critical information
related to different parts of the system. This section explains what each LED indicates when illuminated and any corrective
action you may need to take.
Overheat/Fan Fail
When this LED flashes it indicates a fan failure. W hen on continiously (on and not flashing) it indicates an overheat condition,
which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. Check
the routing of the cables and make sure all fans are present and operating normally. You should also check to make sure that
the chassis covers are installed. Finally, verify that the heatsinks are installed properly. This LED will remain flashing or on as
long as the overheat condition exists.
Indicates network activity on LAN2 when flashing.
Indicates network activity on LAN1 when flashing.
Channel activity for HDDs. This light indicates IDE drive activity when flashing.
Indicates power is being supplied to the system ’s power supply units. This LED should normally be illuminated when the
system is operating.