Acnodes RMC 7155 - Manual (Page 53)

RMC 7155
14” short depth server
53
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
Floppy A
This feature allows the user to select the type of floppy drive connected to the sys- tem as specified. The options are Disabled,
360KB 5 1/4", 1.2MB 5 1/4", 720KB 3 1/2", 1.44MB 3 1/2" and 2.88MB 3 1/2". The default setting for Floppy A is 1.44MB 3 1/
2", and for Floppy B is Disabled.
SATA#1 Configuration
If Compatible is selected, it sets SATA#1 to legacy compatibility mode, while se- lecting Enhanced sets SATA#1 to native
SATA mode. The options are Disabled, Compatible and Enhanced.
Configure SATA#1 as
This feature allows the user to select the drive type for SATA#1. The options are IDE, RAID and AHCI. (W hen the option-RAID is
selected, the item-ICH RAID Code Base will appear. When the option-AHCI is selected, the item-SATA AHCI will be available.)
ICH RAID Code Base (This feature is available when the option-RAID is selected)
Select Intel to enable Intel's SATA RAID firmware to configure Intel's SATA RAID settings. Select Adaptec to enable Adaptec's
SATA RAID firmware to configure Adaptec's SATA RAID settings. The options are Intel and Adaptec.
SATA AHCI (This feature is available when the option-AHCI is selected)
Select Enable to enable the function of Serial ATA Advanced Host Interface. (Take caution when using this function. This feature
is for advanced programmers only.) The options are Enabled and Disabled. If the option-Enabled is selected, the following item
will display.
SATA#2 Configuration (This feature is available when the option-IDE is selected)
Selecting Enhanced will set SATA#2 to native SATA mode. The options are
Disabled, and Enhanced.
IDE Detect Timeout (sec)
Use this feature to set the time-out value for the BIOS to detect the ATA, ATAPI devices installed in the system. The options are
0 (sec), 5, 10, 15, 20, 25, 30, and 35.
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third IDE Master, and Fourth IDE Master
These settings allow the user to set the parameters of Primary IDE Master/Slave, Secondary IDE Master/Slave, Third and
Fourth IDE Master slots. Hit <Enter> to activate the following submenu screen for detailed options of these items. Set the
correct configurations accordingly. The items included in the submenu are:
Type
Select the type of device connected to the system. The options are Not Installed,
Auto, CD/DVD and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive. In the LBA mode, the maximum drive capacity
is 137 GB. For drive capacities over 137 GB, your system must be equipped with a 48-bit LBA mode addressing.
If not, contact your manufacturer or install an ATA/133 IDE controller card that supports 48-bit LBA mode. The options are
Disabled and Auto.