Acnodes RMC 7155 - Manual (Page 43)

RMC 7155
14” short depth server
43
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
Installing/Removing SATA Drives
1. To remove a carrier, push the release button located beside the drive LEDs.
2. Swing the colored handle fully out and use it to pull the unit straight out (see Figure 6-5).
Note: There is no onboard RAID support for SATA drives.
SATA Backplane
The SATA drives plug into a backplane that provides power, drive ID and bus termi- nation. A RAID controller can be used with
the backplane to provide data security for the SATA drives. The backplane is already preconfigured, so there are no jumpers or
switches present on it.
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM drive bay. The RMC 7155 accomodates only
slim DVD-ROM drives. Side mounting brackets are needed to mount a slim DVD-ROM drive into the RMC 7155 server.You
must power down the system before installing or removing a DVD-ROM drive.
Removing the Chassis Cover
1. Grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click").
2. Depress the two buttons on the top of the chassis to release the top cover and at the same time, push the cover away from
you until it stops. You can then lift the top cover from the chassis to gain full access to the inside of the server.