Rmc 7155 – Acnodes RMC 7155 User Manual
Page 7
RMC 7155
14” short depth server
7
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
1-3
Server Chassis Features
The following is a general outline of the main features of the chassis.
System Power
In the RMC 7155, the chassis includes a single 520W power supply.
Serial ATA Subsystem
The chassis was designed to support four SATA hard drives. The SATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-swap capability of the SATA drives (sys-
tem-based RAID is not available for SATA).
Control Panel
The control panel on the provides important system monitoring and control information. LEDs indicate power on, network
activity, hard disk drive activity and system overheat conditions. The control panel also includes a main power button and a
system reset button. The front of the also includes a COM port and two USB serial ports for easy access.
Rear I/O Panel
The 520B's rear I/O panel accommodates one expansion card slot, one COM port (another is internal), two USB ports, PS/2
mouse and keyboard ports, a graphics port and two Gb Ethernet ports.
Cooling System
The chassis has an innovative cooling design that features three 4-cm high-performance system cooling fans. Each of these
fans plug into a chassis fan header on the motherboard. An air shroud channels the airflow generated by the fans to efficiently
cool the processor area of the system.
A fan speed control setting in BIOS allows fan speed to be determined by system temperature [the recommended setting is 3-
pin (Server)].
1.4 Contacting Acnodes
HEADQUARTERS
Address:
Acnodes Corp.
661 Brea Canyon Rd.
Walnut, CA 91789
Tel:
(909) 598-7388
Fax:
(909) 598-0218
info@acnodes.com
Website: