Acnodes RMC 7155 - Manual (Page 19)

RMC 7155
14” short depth server
19
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
5.3 Connecting Cables
Now that the serverboard is installed, the next step is to connect the cables to the board. These include the data cables for the
peripherals and control panel and the power cables.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully routed to prevent them from blocking the flow of
cooling air that moves through the system from the back. If you need to disconnect any of these cables, you should take care
to keep them routed as they were originally after reconnecting them.
The following data cables should be connected.
- DVD-ROM cable
- SATA drive cables
- Control Panel cable
Connecting Power Cables
It has a 24-pin primary power supply connector for connection to the ATX power supply. In addition, there are two 8-pin proces-
sor connectors that also must be connected to your power supply.