Garmin G1000 Piper PA-46 Matrix - Manual (Page 376)

Garmin G1000 Pilot’s Guide for the Piper PA-46 Mirage/Matrix 190-01108-00 Rev. B 362
HAZARD AVOIDANCE
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
Potential Impact Point
Unlighted Obstacle
Projected Flight Path
1000 ft
100 ft Threshold
Terrain more than 1000 ft below the aircraft altitude
Terrain between 100 ft and 1000 ft below the
aircraft altitude
Terrain above or
within 100 ft
below the aircraft
altitude
Figure 6-78 Terrain Altitude/Color Correlation for TERRAIN-SVS
Unlighted Obstacle Lighted Obstacle Potential
Impact Points
Obstacle Location
< 1000’ AGL > 1000’ AGL < 1000’ AGL > 1000’ AGL
WARNING: Red obstacle is above or within
100’ below current aircraft altitude
CAUTION: Yellow obstacle is between 100’
and 1000’ below current aircraft altitude
Table 6-7 TERRAIN-SVS Obstacle Colors and Symbology
TERRAIN-SVS information can be displayed on the following maps:
• PFD Inset Map
• Navigation Map Page
• TERRAIN-SVS Page
• Trip Planning Page
• Flight Plan Pages
• System Page
Displaying terrain and obstacle information (maps other than the TERRAIN-SVS Page):
1) Select the MAP Softkey (for the PFD Inset Map, select the INSET Softkey).
2) Select the TERRAIN Softkey to display terrain and obstacle data.
When TERRAIN-SVS is selected on maps other than the TERRAIN-SVS Page, an icon to indicate the feature
is enabled for display and a legend for TERRAIN-SVS terrain colors is shown.
The Navigation Map Page Setup Menu provides a means in addition to the softkey for enabling/disabling
display of terrain and obstacles. The setup menu also controls the map range settings above which terrain and
obstacle data are decluttered from the display. If a map range larger than the map range setting is selected, the
data is removed from the map. For terrain data, the enable/disable function applies only to the MFD, while the
range setting also affects the PFD Inset Map.
Terrain data can be selected for display independently of obstacle data; however, obstacles for which warnings
and cautions are issued are shown when terrain is selected for display and the map range is within the setting
limit.