Appendix b – Garmin G1000 Piper PA-46 Matrix User Manual
Page 575
190-01108-00 Rev. B
Garmin G1000 Pilot’s Guide for the Piper PA-46 Mirage/Matrix
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
561
APPENDIX b
Performing a database synchronization:
1)
Remove the MFD database card from the bottom card slot of the MFD.
2)
Update the Garmin databases on the MFD card.
3)
Insert the MFD database card into the bottom card slot of the MFD.
4)
Apply power to the system, check that the databases are initialized and displayed on the power-up screen.
When updating the terrain and FliteCharts databases, an ‘in progress’ message may be seen. If this message is
present, wait for the system to finish loading before proceeding to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Make sure the SYNC DBS Softkey is in the enabled state (Figure B-10).
9)
Monitor the Sync Status in the Database Window, wait for all databases to complete synching.
10)
Remove and reapply power to the system, select the AUX-System Status Page, and verify that all databases have
been synchronized.
Canceling an automatic database synchronization:
1)
Turn the large FMS Knob to select the AUX Page group on the MFD.
2)
Turn the small FMS Knob to select the System Status Page.
3)
Press the SYNC DBS Softkey (if needed) to disable (Figure B-10) automatic database synchronization.
4)
Acknowledge the cancellation by pressing the ENT Key.