Bosch GCM 12 SD Professional - Manual (Page 47)

English | 47
Bosch Power Tools 1 609 929 X01 | (1/7/10)
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table. In addition, the cut can be perfomed with or
without slide movement depending on the
width of the profile strip/moulding.
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings Placed
against
the fence Lying flat
on the
saw table
Vertical bevel angle 0° 45°
Floor strip/moulding Left side Right side Left side Right side
Inner corner Horizontal mitre
angle
45° left 45° right 0° 0°
Positioning of
workpiece Bottom edge
on saw table
Bottom edge
on saw table Upper edge
against the
fence
Bottom edge
against the
fence
The finished
workpiece is lo-
cated... ... to the left of
the cut
... to the right
of the cut
... to the left of
the cut
... to the left of
the cut
Outer
corner Horizontal mitre
angle 45° right 45° left 0° 0°
Positioning of
workpiece Bottom edge
on saw table
Bottom edge
on saw table Bottom edge
against the
fence
Upper edge
against the
fence
The finished
workpiece is lo-
cated... ... to the right
of the cut
... to the left of
the cut
... to the right
of the cut
... to the right
of the cut
OBJ_BUCH-1130-002.book Page 47 Thursday, July 1, 2010 11:44 AM