AASTRA DT4x2 for MD Evolution User Guide EN - Manual (Page 99)

99 MD Evolution – Cordless DT412 / DT422 / DT432
Group Services
Standby Status in Hunt Group
When you belong to one or several hunt groups, you may also
manage your availability for answering calls that are directed to
your group(s).
This standby service enables you to temporarily withdraw from a
hunt group. Therefore, you would only receive personal calls, or
those that are directed to the groups from which you have not
withdrawn.
Once again, the system distinguishes your position in relation to
your primary group as well as your secondary groups.
To manage your group standby status, from an idle extension:
68
Dial the prefix “68” to proceed to standby within your primary
group.
æ
Press.
Wait for the Service Acceptance Tone
If your extension was active within your primary group, it will now
be on standby. On the other hand, if your extension was on
standby, it will now be active within your primary group.
In relation to your secondary groups, your extension's active or
inactive status is changed for all of them at the same time.
In either case the service acceptance tone is played.
æ
Press to finish the procedure.
Your extension returns to idle status.
Notes:
The prefix for accessing the standby service within
secondary groups differs from one facility to another.
You may place your extension on standby at any time, even
if you are the last active member of a group. Your status is
managed completely independently from the opening and
closing of traffic for a specific group, which is the sole
responsibility of the hunt group supervisor.