Hotchkis 2269 Sway Bars, Set, 605 Steering Box, 59-64 GM B-Body, Sport User Manual
Page 10
10
9)
Rotate the sway bar so that you can bolt the brackets up to the stud plate in the frame using the
7/16” hardware from kit #T1719. You will only be using four of the nuts and the four smaller
washers on the studs. The four additional nuts and washers are extra hardware not used on this
kit and may be discarded. Tighten the nuts on the brackets and the end link hardware. Torque
the end link hardware to 30ft/lbs.
You can also adjust the stiffness of the bar by changing the hole the end link mounts to. The hole
nearest to the end of the bar softens the bar stiffness by lengthening the bar. The hole furthest from the
end of the bar stiffens the bar by shortening the length of the bar.
10)
Check that all hardware is tight. Cover the grease fittings with the zerk caps provided. Remove
the jack and jack stands and you’re finished installing the sway bar set!