Hotchkis 2269 Sway Bars, Set, 605 Steering Box, 59-64 GM B-Body, Sport User Manual
Page 14
14
»
To accurately determine the location of the holes, the end links must NOT be loose
enough to move left or right. Make certain the axle is at its normal driving height for an
accurate fit.
With the hardware lightly tightened, you can now rotate the bar up, so that
the brackets are resting against the frame. Make sure both clevis brackets lay in the
center of the frame. Position the clevis bracket onto the frame so that it will be possible
to use either hole on the sway bar end.
»
With a marker or scribe, mark the frame for the mounting holes. Drill out the holes to
accept a 7/16” bolt. Do this for both sides.
»
Once the holes are drilled, grab a 7/16” x 1.25” bolt (longer) and a 7/16” washer. Using
a telescoping magnet wand, fish the bolt and washer through the box tubing and set the
bolt into it’s drilled out hole.