Hotchkis 2269 Sway Bars, Set, 605 Steering Box, 59-64 GM B-Body, Sport User Manual
Page 5
5
10)
You can now fully tighten the endlink nuts & bolts. Tighten endlink until the bushing bulges to
the same diameter as the washers.
For cars without a stock front bar
, you will have to connect the end links to the sway bar. Attach the
end link mount bracket included with the kit to the end links and tighten. Rotate the full assembly into
position against the lower a-arm and drill the mounting holes in the arm. Use the 10mm bolts from
hardware kit #T1711 to secure the brackets.
11)
With all of the sway bar components in place and tightened down you can re-attach the
steering. Push the pitman arm back onto the gearbox in the same position as it was removed
.
Don’t worry if it doesn’t slide all the way onto the gear, when you tighten the retaining nut it will
move the arm up the shaft. Re-install the bolts holding the idler arm.