Hotchkis 80111 TVS System, 70-74 Dodge Challenger - Manual (Page 30)

7F. Cut Skid Plate
If your k-frame has a skid plate you will need to cut the front welds that attach the plate to
the k-frame. This will allow you to carefully bend the skid plate downward to allow the new
bar to go in. Use a cut-off wheel or grinder to cut the welds. You will be re-bending and
rewelding the plate back to it’s original position later in this installation.
8F. Install Hotchkis Sway Bar
Insert the Hotchkis front sway bar through the middle of the k-frame like the stock bar use to.
9F. Install New Subframe Bushing Mounts
Install the Hotchkis subframe bushing mounts with the included hardware. Use the fine
thread 3/8 hex bolts for this mount. Make sure to use a washer for the bolt head and the nut
side.