VEGA MoRoS GPRS 1.3 - Manual (Page 22)

Mounting MoRoS GPRS 1.3
22
9 Mounting
This chapter describes how to mount the MoRoS GPRS 1.3 to a DIN rail, connect it to
the power supply and disassemble it again.
Danger!
Exposed electrical components!
Risk of death through electric shock hazard!
Prior to the installation, switch the power of the cabinet
off and secure it against being switched on again.
Danger!
Moisture und liquids from the environment may seep
into the interior of the MoRoS GPRS 1.3.
Risk of death through shock hazard when touching it!
The MoRoS GPRS 1.3 may not be used in wet or damp
environments, or in or very close to water. Install the de-
vice at a dry location, protected from water spray. Switch
the power supply off before you do any work on a device
which may have been in contact with moisture.
Note
The device could be destroyed if the wrong power supply
is used.
If the MoRoS GPRS 1.3 is used with a power supply which
has a larger voltage than the allowed operational volt-
age of the MoRoS GPRS 1.3, the device is destroyed.
Make sure that you use the suitable power supply. The
chapter "Technical Data" has the information about the
correct voltage range for the MoRoS GPRS 1.3.
Mount the device to the DIN rail
Instructions on how to mount the MoRoS GPRS 1.3 to a DIN rail:
1. Position the device at the DIN rail as seen in the following diagram. There
are two snap-in hooks at the outer edge of the DIN rail groove of the MoRoS
GPRS 1.3.
Hook them into place behind the upper edge of the DIN rail when connecting
the device.