VEGA MoRoS GPRS 1.3 User Manual
Page 27
MoRoS GPRS 1.3
Initial Operation
27
5.
Using one finger, carefully push the SIM card holder with the inserted SIM
card into the housing, until the card holder snaps into place.
6.
Switch the power supply of the MoRoS GPRS 1.3 back on.
MoRoS GPRS 1.3 configuration
The MoRoS GPRS 1.3 is connected to the PC.
The power supply of the MoRoS GPRS 1.3 is switched on.
You have the required access rights to change the IP address of the network
card to which the MoRoS GPRS 1.3 is connected.
1.
Change the IP address of the network card to which the MoRoS GPRS 1.3 is
connected to an address which starts with 192.168.1.
As an alternative, you may also configure your network card to "Automatic
address allocation". The integrated DHCP server of the MoRoS GPRS 1.3 will
then allocate an address from the according address range to your network
card.
Do not use the address 192.168.1.1. This is the IP address of the MoRoS
GPRS 1.3, set as factory default. For example, use 192.168.1.2 as IP address
for the network card in your PC.
2.
Open an Internet browser and point it to the URL "http://192.168.1.1".
The web browser will load the start page of the MoRoS GPRS 1.3.
If you see the message in your browser window that the page with this ad-
dress cannot be found, follow the following steps: Check if your MoRoS GPRS
1.3 receives power. If yes, most probably the wrong IP address is set in the
MoRoS GPRS 1.3. In this case, reset your device to the factory defaults by
pressing the reset key three times for a short time and repeat step 2.
A dialogue will prompt you to enter a user name and password for authen-
tification.
3.
Enter the user name "insys"
and the password "moros".
User name and password are set as factory defaults. If the registration at
the web interface does not work with the data entered, just reset your Mo-
RoS GPRS 1.3 to the factory defaults:
Press the reset key at the MoRoS GPRS 1.3 three times within one second
and repeat this instruction from step 2.
You should now see the start page of the web interface.
The MoRoS GPRS 1.3 is successfully installed and ready for configuration.