VEGA MoRoS GPRS 1.3 - Manual (Page 56)

Functions MoRoS GPRS 1.3
56
ter the page has been reset, you can view the states of the inputs on the same
page next to "Input 1:" and "Input 2:" (Figure 16, page 36, above, position 2).
12.8.2 Set up a Dial-out Connection via Switch Input
The MoRoS GPRS 1.3 can establish a preconfigured dial-out connection, after the input
IN2 is closed for 4 seconds, i.e. connected to "GND". When activating the input, a dial-out
is performed as configured in the according menu. The connection will remain as long as
the connection configuration allows.
Configuration with the web interface
To trigger a dial-out connection by closing IN2, activate the checkbox "Trigger
a dial-out connection through input IN2 ..." (Figure 17, page 37 above, position
1) .
Save the settings by clicking "OK" (Figure 17, page 37 above, position 2).
12.8.3 Trigger SMS Dispatch through Input 1
The MoRoS GPRS 1.3 can send an SMS to a phone number when closing the input 1.
There are two pulse types: a long pulse with a duration of a minimum of 4 seconds, and
individual pulses, which are shorter than 1 second.
The long pulse triggers the SMS message for the simple alarm. The short pulses trigger
the dispatch of the SMS messages for the according number of pulses.
SMS messages can be up to 140 characters long.
Dial-out and dial-in connections have priority over the sending of SMS. If a request to
send an SMS arrives during a connection, this SMS will only be sent after the existing
connection is terminated. If several SMS requests arrive during a connection, they are
buffered and then sent after the termination of the connection, individually and in suc-
cession.
Configuration with the web interface
To switch the sending of SMS messages on, first activate the checkbox "SMS
dispatch when changing ..." (Figure 18, page 37 above, position 1).
To make sure that the sending of SMS works, enter the number of an SMS ser-
vice center in the entry field "SCN (Service Center Number)" (Figure 18, page
37 above, position 8). If your MoRoS GPRS 1.3 is connected to a telphone sys-
tem, enter the number for getting an outside line together with the service
center number.
If necessary (not for GSM/GPRS), select the SMS protocol of your SMS service
center in the dropdown menu "SMS protocol" (Figure 18, page 37 above, posi-
tion 2). Your SMS service center provider will tell you which protocol to use.
To send a message through an individual, 4 second pulse, enter a destination
phone number in the entry field "Phone number" (Figure 18, page 37 above,
position 3). The number format depends on the requirements of the service