VEGA MoRoS GPRS 1.3 - Manual (Page 26)

Initial Operation MoRoS GPRS 1.3
26
10 Initial Operation
This chapter describes how to activate the MoRoS GPRS 1.3, i.e. how to connect the
MoRoS GPRS 1.3 to a PC, and how to prepare it for the configuration.
Connect the MoRoS GPRS 1.3 to a GSM antenna and a PC
How to connect the MoRoS GPRS 1.3 to a PC via a network cable interface.
The power supply of the MoRoS GPRS 1.3 is switched off.
You will need Cat. 5 network patch cables.
You will need a network card at the PC.
You will need a suitable GSM antenna (available from IN-
SYS MICROLECTRONICS).
1. Locate the RJ45 jack of the network card at the PC.
2. Make sure not to use the ISDN jack, but the jack of the network card, which
you want to use to configure the MoRoS GPRS 1.3.
3. Plug one end of the network cable into the RJ45 jack of the PC network card,
and the other end into a network jack at the MoRoS GPRS 1.3 switch.
4. Connect the GSM antenna to the antenna jack of the MoRoS GPRS 1.3.
Insert the SIM card into the MoRoS GPRS 1.3.
How to insert the SIM card into the MoRoS GPRS 1.3.
The power supply of the MoRoS GPRS 1.3 is switched off.
You will need a working SIM card of your mobile provider.
You will also need the according PIN.
You will need a pointed object to operate the eject button of the SIM card
holder, e.g. a screwdriver with a 1.5 mm blade.
1. Press the eject button of the SIM card holder with the pointed object.
The SIM card holder will slide a little bit further out of the housing.
2. Remove the SIM card holder.
3. Insert your SIM card into the card holder.
The SIM card will only fit into the SIM card holder in one position.
Make sure that the SIM card does not extend over the card holder.
4. Insert the SIM card holder together with the SIM card into the MoRoS GPRS
1.3. The contacts of the SIM card must face the left housing wall.