VEGA MoRoS GPRS 1.3 - Manual (Page 60)

Functions MoRoS GPRS 1.3
60
12.10.6 Updating the Firmware of the MoRoS GPRS 1.3
You can update the firmware of the {{PRODUKTBEZEICHNUNG}}}. The firma is a combi-
nation of operating system and programs, in which the functions of the {{PRO-
DUKTBEZEICHNUNG}}} are implemented. To update the firmware, you will need two files
with a new firmware, which you may receive from your sales partner, or from IN-
SYS MICROELECTRONICS.
Note
Function loss due to faulty update!
During a connection termination during the update and
a following restart, the MoRoS GPRS 1.3 may loose its
function.
As long as the red LED at the MoRoS GPRS 1.3 lights up,
you are not permitted to perform any actions at the web
interface, you should not pull the power plug and you
should not perform a reset.
After a failed update, do not restart the MoRoS GPRS 1.3,
but call the INSYS MICROELECTRICS support.
Note
Loss of availability!
Through a firmware update, your MoRoS GPRS 1.3 may
use its earlier configuration. Your MoRoS GPRS 1.3 can
then only be accessed from the local network via its
standard IP address 192.168.1.1.
Perform critical updates only locally, read the file "Re-
adMe.txt" that comes with the firmware, or contact the
INSYS MICROELECTRONICS support.
Complete update of the MoRoS GPRS 1.3 firmware
The following steps must be performed to update the firmware of a MoRoS
GPRS 1.3.
You have access to the web interface.
If you access the web interface of the MoRoS GPRS 1.3 via a dial-up connec-
tion, the connection must be maintained long enough to perform the up-
loads. The option "Maximum connection time" should be set to "0" for the
update, also for the "Idle time".
You have ensured that the power supply of the MoRoS GPRS 1.3 can not be
switched off during the update procedure.
You have both firmware files; one file with the name "ulmage" and a sec-
ond one with the name "uRamDisk". The files can be found on the PC from
which you want to perform the update.