Sony MEX-BT5100 - Manual (Page 6)

6
Getting Started
Resetting the unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ballpoint
pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Setting the clock
The clock uses a 24-hour digital indication.
1
Press (MENU).
2
Push the joystick up/down until
“Setup” appears, then push it right.
3
Push the joystick up/down until “Clock
Adjust” appears, then push it right.
4
Push the joystick up/down to set the
hour and minutes.
To move the digital indication, push the
joystick left/right.
5
After setting the clock, press the
joystick.
The clock starts.
Tip
You can set the clock automatically with the RDS
feature (page 14).
Adjusting the volume level of
each device
When connecting to a portable audio device via
the BUS AUDIO IN/AUX IN terminal, we
recommend adjusting the volume level of the
connected device, or adjusting the volume level
for the connected device in the Setup menu on
this unit. See “Adjusting the volume level”
(page 22) for a device connected to AUX IN.
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press (OPEN).
The front panel is flipped down.
3
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
RESET
button
1
2