Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger '03-07 Compatible w_ Optional Banks iQ - Manual (Page 15)

96824 v.3.0
15
ALL MODELS
37.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly
to 35 ft-lbs. Make sure that each slip
is fully inserted (+/- 1 ⁄ 4 inch) and that
all mount hangers are in the forward
position (see Figure 7). Torque 7 ⁄ 16 ”
hanger bracket hardware to 45 ft-lbs.
38.
Remove the protective covering
from the tailpipe tip.
Caution: The protective covering
may ignite and burn if not
removed prior to running the
engine.
39.
Tighten the exhaust clamps as
necessary. Whenever possible, tack-
welding slip connections to prevent
disengagement is recommended. The
Banks Monster Exhaust installation is
now complete.
-END, SEcTION 1-
BANKS
DRIVER SIDE
TAILPIPE
ZIP TIE ON
VENT HOSE
& BRAKE LINE
BANKS
PASSENGER SIDE
TAILPIPE
ADJUST SO THAT
SPARE TIRE TO
TAILPIPE CLEARANCE
IS THE SAME
MOVE SPARE
TIRE TOWARDS
REAR OF
VEHICLE
Figure 6
Figure 7