Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger '03-07 Compatible w_ Optional Banks iQ - Manual (Page 30)

30
96824 v.3.0
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANkS
iQ IS DESIGNED TO SuPPLy
A CONSTANT LOW-VOLTAGE
POWER SOuRCE (+5VDC) TO
THE BANkS iQ AND IS “LIVE”
AS LONG AS THE SySTEM’S
OBD II INTERFACE CABLE OR
BANkS WIRING HARNESS IS
COMPLETELy INSTALLED AND
THE uSB CABLE CONNECTOR
IS PLuGGED INTO BANkS iQ.
ALTHOuGH THIS CHARGING CABLE
IS SHORT AND ITS CIRCuITRy IS
FuSE-PROTECTED, THE uSER IS
ExPECTED TO TAkE APPROPRIATE
MEASuRES TO PREVENT SMALL
CHILDREN AND/OR PETS FROM
CONTACT WITH ANy PART OF THIS
SySTEM.
11.
Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
12.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
13.
Reinstall the lower knee panel
back in place with the factory
hardware. Tuck any excess cable
behind it for a clean appearance.
-END, SEcTION 5-
Figure 40 Suggested Mounting location for Banks iQ
Figure 41
Figure 42 Ford (’05-07)