Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger '03-07 Compatible w_ Optional Banks iQ - Manual (Page 27)

96824 v.3.0
27
21.
2005-07 model year vehicles
only: Remove the adhesive backing
from two (2) dual-lock fasteners and
attach them to the EconoMind shield
and attach the other end to the top of
the fuse box.
22.
Remove the adhesive backing
from the (2) dual-lock fasteners on the
back of the EconoMind Diesel Tuner
and affix the tuner to:
2003-04 model year vehicles: The
inner driver side fender as shown in
Figure 27.
Note: Shield will not be used for
installations on 03-04 models.
Shield will only be used on 05-07
models.
2005-07 model year vehicles: The
inside roof of the EconoMind shield,
that is mounted on the fuse box cover
as shown in Figure 28 & 32.
23.
Re-install the plastic driver side
battery box. Torque the attachment
bolts to 12 ft-lbs.
24.
Re-install the driver’s side
battery, battery hold down clamp, and
plastic battery cover. Torque the hold
down clamp retaining bolt to 89 in-lbs.
WARNING: When lifting a battery,
excessive pressure on the end
walls could cause acid to spew
through the vent caps, resulting
in personal injury. Lift with a
battery carrier or with hands
on opposite corners. Failure to
follow these instructions may
result in personal injury.
25.
For 2003-04 4-wheel drive
equipped vehicles only: Re-install
the electronic module near the driver
side battery. The module is shown in
Figure 37.
26.
Re-install the driver and
passenger (+) and (-) battery cables
-END, SEcTION 4-
Figure 33
Figure 34
Figure 35