Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger '03-07 Compatible w_ Optional Banks iQ - Manual (Page 38)

38
96824 v.3.0
If the EconoMind Tuner should ever
need to be removed from the vehicle,
perform the following:
Note: The ignition must remain in the
OFF position throughout the removal
process.
1.
Disconnect the EconoMind 46-pin
connector (connector c) from the
middle connection on the PcM.
2.
Re-connect the vehicle’s 46-pin
connector back into the middle
connection on the PcM.
3.
Disconnect the EconoMind MAP
connections from the vehicles MAP
sensor and harness. Re-connect the
vehicle’s MAP connector back into
the MAP sensor.
4.
Disconnect the 2-ring terminals
from the EGT thermocouple.
5.
Disconnect the 3 small connectors
on the ‘In-cab cable’ and gently pull
the cable back through the firewall.
6.
Remove the EconoMind Tuner.
Failure to follow the above
instructions when removing the
module will result in a “check
Engine” light on the dash and a
Diagnostic Trouble code being stored
in the factory computer, in addition
to the engine not running.
-END, SEcTION 10-
Section 10
REMOVAL OF THE ECONOMIND DIESEL TuNER
Section 11
PLACEMENT OF THE BANkS POWER DECAL
Figure 55: Placement of the Banks decals