Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger '03-07 Compatible w_ Optional Banks iQ - Manual (Page 26)

26
96824 v.3.0
Note: If you are not installing the
optional Banks iQ then coil up and
secure cable with the RJ12 (telephone
style) connector end.
17.
Remove the fuse box cover,
located in the cabin compartment.
Locate the mini-fuse #22 and remove.
Install the mini-auto blade fuse tap
onto the removed mini fuse as shown
in Figure 34 Re-install the mini fuse
with the attached blade tap into
location #22 as shown in Figure 35.
18.
Locate the RED single terminal
connector on the ‘OBDII Interface
cable’ and connect it to the mini-
fuse blade tap location #22. Replace
the fuse cover and make sure not to
pinch the RED single terminal wire.
Mounting The EconoMind Diesel
Tuner
19.
2003-04 model year vehicles
only: Remove the clip shown in
Figure 37 to create adequate room
to mount the EconoMind Diesel Tuner
to the driver side inner fender.
20.
2003-04 four-wheel drive
vehicles: The module shown in
Figure 37 will appear only in four-
wheel-drive vehicles. This may need
to be relocated to make room for
the EconoMind Diesel Tuner. The
mounting location of this module by
the factory has not been consistent
on early vehicles.
NOTE: Make sure the entire mounting
surface is clean and free of dirt and
oil before mounting the EconoMind
Diesel Tuner. Clean and dry as
required using a cloth damped in
rubbing alcohol or similar cleaning
solution.
Figure 31
Figure 30
Figure 32