Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) PowerPack & Stinger-Plus systems (connects to pump wire) User Manual
Page 15
plug mounted in the firewall slightly
above and to the right of the steering
shaft, as viewed facing the firewall
through the engine compartment.
Make a cross-shaped incision in the
plug and reinstall it in the firewall. See
Figure 9.
For manual transmission models,
make an incision in the main wiring
loom grommet above the wire bundle.
Take care to not cut any wiring. See
Figure 9.
Insert the black twist connector on
the OttoMind wire loom provided
through the grommet from the engine
compartment side.
39.
Locate the two black wire sheaths
covering four black wires at the top
back portion of the fuel injection
pump. See Figure 10.
Caution: It is very important that
you select the proper wire. The
Banks OttoMind will not function
properly if installed incorrectly.
40.
At the front of the intake
manifold, remove the three bolts
holding the throttle bracket assembly
to the head. Move this assembly
toward the driver’s side battery. This
will allow easier access to the fuel
pump wiring.
41.
Locate a black wire tap connector
and a packet of dielectric grease in
the Banks system. Squirt a generous
Figure 8
96397 v.8.0
15